Freeform filleting#1

It would be great to support freeform filleting within Phi.

It would be great if the way this could work is if the user could hold down shift, then click on a line and there’s an autochaining command that predicts where the seam would start and end on your geometry. The user could quickly shorten or lengthen the ends or redirect to the right branching route for a proper selection. Then once the proper selection is made on the seam, click and hold down shift again for example, and drag up or down to create an offset spline chain line attached to a dynamic fillet. After you let go, you also have the option of placing a specific sized fillet by typing a number.